molex wiring?

[diminion]

im finishing sleeveing my power supply and im putting back the plastic molex on the pins when i thought: Do the order the the black wires matter? I know the yellow on the left and the red on the right. But then there are 2 balck cables, does it matter which order thses go into? Im pretty sure they dont but then agian i dont know that much about power so...
thanks

[lemonlime]

I actually had the same thought after completing my sleving job on my old antec psu. I did not take any care to keep them matched up, and the system had no issues (thankfully) :mullet: . The grounds should all terminate to the same place in the psu, so It really shouldn't matter.

[Tex]

Black is ground. Ground is ground so don't worry about it.

One piece of advice based on years and years of PC maintenance.

Use somethig like plastic welder ( a plastic based epoxy) and put a drop or two on each wire of each molex.

Helps a ton. Best 3 bucks you will spend

Tex

[diminion]

okay thanks guys. wasnt 100% sure about that why i posted.