Morgoth_Bauglir
20 Jul 2005, 1:19am
I was happiliy shutting down my PC to pull out my RAM which I am sending off in the mail.
It shut down, I pulled out the power cable, took off the case side and put the case on it's side.
Now with the NF7-S, the RAM slot clips can't open whilst the 6800 is in as they would hit against it.
So I get my 6800 out with a small bit of effort getting the little AGP clip down, put it over on a stack of boxes in the corner of my room.
I opened up DIMM1 and pulled out the said RAM, I put the second stick in DIMM1 and put the 6800 back in.
I stood up the case again and plugged the power in, the mobo light came on, I hit the button and my computer turned on for a split-second, not enough to spin up any fans even, I saw the faint light from the 6800 fan and it was off again, with the mobo light still on.
I get a beep sound whilst it is on for the split second too.
I doublechecked all power cords and tried again, I had to pull out the power calbe and plug it in to get any other response, same result.
I pulled out the watercooling, put the HSF on, unplugged fans except for CPU, unplugged the secondary HDD and the DVDRW.... All that was connected was one HDD and the CPU fan and everything on the mobo. - Still same result.
Tried a different PSU, no improvement there either.
Put the RAM back in, and tried different combinations, no go.
The 6800 is not dead as the fan still starts to spin and the LED goes for a sec, the CPU has no visible damage whatsoever either, no cracks, bent pins or chips to be seen.
The only thing I can think of is a short under the mobo, maybe a magnet from the watercooling went underneath when I sat the case on its side or a screw or two found their way in somewhere.
What do you think?
It shut down, I pulled out the power cable, took off the case side and put the case on it's side.
Now with the NF7-S, the RAM slot clips can't open whilst the 6800 is in as they would hit against it.
So I get my 6800 out with a small bit of effort getting the little AGP clip down, put it over on a stack of boxes in the corner of my room.
I opened up DIMM1 and pulled out the said RAM, I put the second stick in DIMM1 and put the 6800 back in.
I stood up the case again and plugged the power in, the mobo light came on, I hit the button and my computer turned on for a split-second, not enough to spin up any fans even, I saw the faint light from the 6800 fan and it was off again, with the mobo light still on.
I get a beep sound whilst it is on for the split second too.
I doublechecked all power cords and tried again, I had to pull out the power calbe and plug it in to get any other response, same result.
I pulled out the watercooling, put the HSF on, unplugged fans except for CPU, unplugged the secondary HDD and the DVDRW.... All that was connected was one HDD and the CPU fan and everything on the mobo. - Still same result.
Tried a different PSU, no improvement there either.
Put the RAM back in, and tried different combinations, no go.
The 6800 is not dead as the fan still starts to spin and the LED goes for a sec, the CPU has no visible damage whatsoever either, no cracks, bent pins or chips to be seen.
The only thing I can think of is a short under the mobo, maybe a magnet from the watercooling went underneath when I sat the case on its side or a screw or two found their way in somewhere.
What do you think?