Crash and Burn! Help!

[Radio91P]

I just finished building a computer. I had the CPU fan voltage at 6 and changed it to 6.5. When I saved the changes and the computer tryed to boot it would not. It wont even try and post. I tried to use the cmos jumper and no luck. I don't know what to do from here. Help!@

AMD Athlon 64 3200+
A8N-FM OEM
1GB corsair valueselect.
Nvidia 6800 GT
350 W powersupply.

Thanks for the help guys!
Radio91P

[Leonardo]

Have you removed the CMOS battery? If not, remove for an - better overnight, then see if the computer will let you into the BIOS.

[Radio91P]

ok thanks

[edcentric]

remember the steps. unplug, move jumper, remove battery.
In the morning replace the battery, move the jumper back and plug it back in.
good luck.

[Radio91P]

I will try that!
Wish me luck!

I love computers!:Pwned:

[Radio91P]

Well, I have to laugh at myself for this one. After I couln't post I went to pull the jumper and pulled the rom jumper. I then left it on recovery. Then trying to rejump it the right way I coudn't get it to post. Finally I followed the steps and left it alone for about 2 hours. Then it boots. Now its saying that there is a bad rom. So fiddle around and get the bios file on a disk. For some cockeyed reason I could not get it to load. Finally I decided I should mess around with the floppy and see if everything was connected right. I ended up having the floppy cable flipflopped on the floppy drive. Finally, I have everything running very quick. YEEAAAHHHH!!!!

Anyway, Thanks for the help.

Life is a buger, so eat it!
Radio91P:Rocker:

[Leonardo]

You are in good company. I know I've done things just as goofy as that before, like trying forever to get a 'dead' motherboard to POST with the CMOS jumper in the reset position. :rant: