92MM fan reccommendations?

[GHoosdum]

I'm looking for a 92MM fan to use with my SLK-900A.

Requirements:
>60CFM
<40dB
Ball bearing
<$20 shipped

Preferences:
Small center hub
4-pin power lead with 3-pin RPM monitoring lead
<$15 shipped

Fire away!

[TheBaron]

if you can get more than 60cfm on less than 40db lemme know, cause i want one too. the panaflo's might be close

[Black Hawk]

The Thermoflow TF-9225 (http://www.plycon.com/fans/thermoflow92.htm) and Thermaltake TT-9025 (http://www.plycon.com/fans/therm92.htm) look nice.

[GHoosdum]

TheBaron had this to say
if you can get more than 60cfm on less than 40db lemme know, cause i want one too. the panaflo's might be close

Here's the best I've found so far... but it doesn't have 4 pin power AND 3 pin RPM, just a convertor...
SVC - Enermax (http://www.svc.com/en92vasphipe.html)

Black Hawk had this to say
The Thermoflow TF-9225 (http://www.plycon.com/fans/thermoflow92.htm) and Thermaltake TT-9025 (http://www.plycon.com/fans/therm92.htm) look nice.

Neither one of those beats that Enermax tho... ;) In fact, neither one of those really beats out the 53CFM Mechatronics fan I've got right now...

[mmonnin]

Same thing here. I was looking for one with about the same requirements and the Enermax is your best bet.

[GHoosdum]

I'm not going to burn out my mobo fan header by putting such a load on it?

[Black Hawk]

I've only seen a Delta burn a fan header but you could always use an adapter to be safe.

[SimGuy]

The 92mm Panaflo H1A comes in with 57 CFM @ 35 dBA.
The 92mm Panaflo U1A comes in with 69 CFM @ 43 dBA.

Both can use either the 4-pin molex or 3-pin fan-header, but do not offer RPM monitoring. :(

Not sure on US price ($27.00 CDN a piece).