Mosfet & SB Sinks

[Al_Capown]

Does anyone have any recommendations for mosfet sinks or a SB sink. I'll most likely be using Arctic Silver Adhesive so this will be permanent and I would like to use the best available.

I need 1x SB cooler & 6x Mosfet Sinks.

If anyone has anything inparticular please do share. I prefer to either buy from Newegg or SVC, or if there's a retail nation-wide store that'd be nice too.

[TheLostSwede]

http://www.directron.com/oczminisink.html
http://www.directron.com/silveramsinks.html
http://www.directron.com/oczbgaram.html
http://www.directron.com/zmnb47j.html


Just cut the "legs" off the Zalman and glue it on with epoxy.

[Al_Capown]

Hrm i've got a zalman here right in front of me.... So you're saying cut off the legs then with the cube basicly cut it into four pieces?

[TheLostSwede]

I mean cut the things for the holes on the NB off. Or isn't it flat underneath?

[Al_Capown]

Yea I see what you're saying, but after that should I cut the base into 4 cubes? Since the thing is a bit large to fit inbetween those capacitors.

[TheLostSwede]

Nah. Get some of the small coolers that already are in the right sizes.