Hi there,

I know that board have some issues with 1T so please try 2T first and the following settings to see if the ram is stable at "stock" speeds.

FSB Bus Frequency............................250
LDT/FSB Frequency Ratio.......................800 or 4X
CPU/FSB Frequency Ratio.......................10
PCI eXpress Frequency.........................100

CPU Voltage ..................................1.4V
LDT Voltage ..................................N/A
ChipSet (NF4) Voltage ........................Overvolt enabled
DRAM Voltage .................................2.8
+0.03 if not 3.2V ............................

Memclock (DRAM Frequency) ....................200
1T/2T Timing (Command Per Clock)..............2T
CAS Latency (Tcl).............................3 or 2.5 (test was with 2.5)
RAS# to CAS# delay (Trcd).....................3
Min RAS# active time (Tras)...................6
Row precharge time (Trp)......................2
Row Cycle time (Trc)..........................8
Row refresh cyc time (Trfc)...................24
Row to Row delay (Trrd).......................3
Write recovery time (Twr).....................3
Write to Read delay (Twtr)....................2
Read to Write delay (Trwt)....................2
Refresh Period (Tref).........................7.8us
DRAM Bank Interleave..........................auto

DQS Skew Control..............................auto
DQS Skew Value................................
DRAM Drive Strength...........................Normal
DRAM Data Drive Strength......................auto or not reduced
Max Async Latency.............................7ns
DRAM Response Time............................N/A
Read Preamble Time...........................5.5
IdleCycle Limit...............................16 bios default
Dynamic Counter...............................enabled bios default
R/W Queue Bypass..............................8X
Bypass Max....................................7ns
32 Byte Granularity...........................4 beats