Intel D875PBZ setup

GarethGareth Wales
edited July 2003 in Hardware
Intel D875PBZ setup
I've just finished building a new box using this Intel board.
There is just one thing which I am unable to configure, which is wake up from ps2 keyboard.
When I shut down by selecting "standby" (S3 state) the PC will boot up when any key is pressed.
However if I shut down by selecting "Turn off" I am unable to boot unless I press the power switch.
My other two boxes, a GigaByte BX2000 and a GigaByte 7VTXH will both recover from being switched off with the press of a key.
The intel manual mentions resume from PS2 but I can't find anything else in the BIOS.

<< Table 10. Wake-up Devices and Events
These devices/events can wake up the computer… …from this state
LAN S1, S3, S4, S5 (Note)
Modem (back panel Serial Port A) S1, S3
PME# S1, S3, S4, S5 (Note)
Power switch S1, S3, S4, S5
PS/2 devices S1, S3
RTC alarm S1, S3, S4, S5
USB S1, S3
Note: For LAN and PME#, S5 is disabled by default in the BIOS Setup program. >>

Has any one got this motherboard to work in this way ?

Thanks Gareth.

PS the full spec....
Intel D875PBZ with P4 2.4c. Zalman cnps7000, 512M Twinmoss DDR400, Matrox G550 graphics card, Seagate SATA 80 Gig. Enermax 350w PSU, Pioneer DVD ROM, CoolerMaster 210 case.

Comments

  • TheLostSwedeTheLostSwede Trondheim, Norway Icrontian
    edited July 2003
    Can you have a look in the manual (cant dl it myself) for any jumpers where you can activate/deactivate wake on? Some boards have that on jumpers and/or in bios. My NF7 have it on jumpers and bios.
  • GarethGareth Wales
    edited July 2003
    I've checked the manual again, but can't find any relevant jumpers.

    Thanks... Gareth
Sign In or Register to comment.