Dual Xeon Motherboard, 2 Processors, 2 Heatsinks
Donut
Maine New
I'm finally retiring my dual Xeon setup, and here's what I have.
Board, 2 procs and 2 heatsinks.
Board- Asus PC-DL. http://www.asus.com/products.aspx?l1=9&l2=39&l3=99&model=104&modelmenu=2
Procs (2) 1.6ghz LV Xeon (SL6xk)- For some reason I can't get it to pop up on Intels Spec page (the stepping) I do know they're 1.3v procs.
2 heatsinks- Coolermaster heatpipes-Linky
This is the above items here:Intel Overclock database
I'm asking 250.00 shipped in the US. Paypal or USPS money order.
Would consider a trade for a decent LCD monitor or vid card of approx. value.
This is an overclocked setup, it is currently running at the above speeds with 4 f@h instances. It has been running at these speeds since Feb 2005
I will be shipping with the procs in the board as there are a couple of U-wires in each socket for 1.5v operation, and 1 pin on each proc has been insulated for 200 fsb operation.
General notes about this setup-
It DOES use standard DDR ram, though I would highly recommend high speed low voltage ram (I'm using cheap pc-4000) board only has 2.5v to ram, unless you mod it.
A good strong PSU- I'm using a Sparkle 550w with 36a on a single 12v rail, I don't know how it works with split rail PSUs
Actively cool the heatsinks, a couple of 80mm fans will do the trick.
Thanks for looking
Donut
Board, 2 procs and 2 heatsinks.
Board- Asus PC-DL. http://www.asus.com/products.aspx?l1=9&l2=39&l3=99&model=104&modelmenu=2
Procs (2) 1.6ghz LV Xeon (SL6xk)- For some reason I can't get it to pop up on Intels Spec page (the stepping) I do know they're 1.3v procs.
2 heatsinks- Coolermaster heatpipes-Linky
This is the above items here:Intel Overclock database
I'm asking 250.00 shipped in the US. Paypal or USPS money order.
Would consider a trade for a decent LCD monitor or vid card of approx. value.
This is an overclocked setup, it is currently running at the above speeds with 4 f@h instances. It has been running at these speeds since Feb 2005
I will be shipping with the procs in the board as there are a couple of U-wires in each socket for 1.5v operation, and 1 pin on each proc has been insulated for 200 fsb operation.
General notes about this setup-
It DOES use standard DDR ram, though I would highly recommend high speed low voltage ram (I'm using cheap pc-4000) board only has 2.5v to ram, unless you mod it.
A good strong PSU- I'm using a Sparkle 550w with 36a on a single 12v rail, I don't know how it works with split rail PSUs
Actively cool the heatsinks, a couple of 80mm fans will do the trick.
Thanks for looking
Donut
0
Comments
Hey, it's a little more creative than typing "bump"