Dremel!

EnverexEnverex Worcester, UK Icrontian
edited October 2003 in Hardware
I didn't realise how cheap they were, I thought they were like £150 or something.

Anyway, I found out the one with a 5 piece set is £35 pretty much everywhere, so I think I am going to buy one.

I am most likely going to buy it from here - http://www.tooled-up.com/Product.asp?PID=110485

As underneath they have a 145 Piece set for £20, and I was just wondering if this lots will work together and will I have what I need to sand down sharp edges on a case (after cutting out a fan grill, basically the sharp bits left round the edge of there).

Didn't realise they were made by Bosch either, nice reliable name.

Cheers,
NS

Comments

  • seversphereseversphere
    edited October 2003
    after cutting the case grilles with a left cutting metal shear I use the generic orange grinder and then finish it with the wire brush. Read the instructions for each attachment so you know what rpms they are meant for. Don't forget safety glasses.
  • SimGuySimGuy Ottawa, Canada
    edited October 2003
    I used the sanding drum at a moderate RPM to "45" the edges of the blowholes I cut in my case earlier this week.

    I used a total of 3 of those sanding drums on 6 blowholes, but it perfectly smoothed the edges out and rounded them perfectly.
Sign In or Register to comment.