For sale/trade 1 GB PC133 for an Athlon XP cpu
Tim
Southwest PA Icrontian
I bought 1 GB of NEW PC133 memory (2 512 MB sticks) for a Biostar motherboard I had been given for free. Free because it needed a BIOS chip. But I found out that getting a new BIOS was more cost and hassle than I wanted to put into it.
So after doing research on Micro ATX motherboards, I find that I have far more choices in DDR memory boards.
So now I don't need this 1 GB of SDRAM. I now need 1 GB of PC3200.
I think a trade like that is unlikely to happen, so I'd like to either sell these 2 sticks for $110 total (make offer), or trade them for an AMD Athlon XP+ 2600 or 2700 or 2800 CPU.
I installed these memory sticks in a computer, and according to CPU-Z 1.30, here are the specs. It was sold as not being Micron memory, but made with Micron chips. And they have blue heat spreaders riveted onto them.
Manufacturer - Micron Technology 64M X 64 chips
Part # 512ucunzwmea
3-3-3-6 133 Mhz
Anyone interested?
So after doing research on Micro ATX motherboards, I find that I have far more choices in DDR memory boards.
So now I don't need this 1 GB of SDRAM. I now need 1 GB of PC3200.
I think a trade like that is unlikely to happen, so I'd like to either sell these 2 sticks for $110 total (make offer), or trade them for an AMD Athlon XP+ 2600 or 2700 or 2800 CPU.
I installed these memory sticks in a computer, and according to CPU-Z 1.30, here are the specs. It was sold as not being Micron memory, but made with Micron chips. And they have blue heat spreaders riveted onto them.
Manufacturer - Micron Technology 64M X 64 chips
Part # 512ucunzwmea
3-3-3-6 133 Mhz
Anyone interested?
0
Comments
Just figured I'd post this reminder for folks looking for ram for their old Intel boards, Tim.
The ST-6 has 3 DIMM slots and a 512 MB maximum memory limit.
And I ran the computer using only 1 of each of these 2 sticks, and they both worked fine, albeit showing 256 of the 512 in the ST-6 because of its memory limitations.
[EDIT] Tim, I wasn't referring to you.
Thanks
Welcome to Short-Media and thank you for your first post. Make yourself comfortable here and check out our other forums as well!
Thanks for your advice I went to his web site and sent him a message. Since i am new here i didn't realize i could send a private message via this site. I'll look that up.
Thanks again
any other advice is welcome.