SmartBridge Alerts: MotiveSB.exe - Entry Point Not Found???

krazychris2krazychris2
edited November 2006 in Science & Tech
Hi Everyone, I just recently worked with the virus forum and finally cleaned up my computer, however the only problem that we couldn't resolve was the fact that my wireless card doesn't seem to be working (I cannot connect to the internet via wireless) I can however connect via LAN, Linksys told me it might be a hardware issue, however whenever I start my computer I get this error message:


SmartBridge Alerts: MotiveSB.exe - Entry Point Not Found
The procedure entry point GetProcessImageFileNameW could not be located in the dynamic link library PSAPI.DLL.


I dunno if this has anything to do with me not being able to access wirelessly, also I cannot access the internet while my ZoneAlarms Firewall is up. Could some one please help me.

Sincerely, Chris :doh:

Comments

  • mtroxmtrox Minnesota
    edited November 2006
    krazychris2 wrote:

    I dunno if this has anything to do with me not being able to access wirelessly, also I cannot access the internet while my ZoneAlarms Firewall is up. Could some one please help me.

    In the newer versions of ZA that have been out the past year, by default they block a lot of DNS traffic. I think it's in the firewall tab, Advanced settings there are a couple of boxes you check to allow DNS/DHCP traffic in the trusted and internet zones.

    As for the error, apparently its pretty common after upping to IE7. Check out this thread (among many, many others) for a solution.
  • krazychris2krazychris2
    edited November 2006
    Thanks Mtrox I appreciate the help, so far its looks like the annoying message is gone. Do you think I should go to the hardware forum for the wireless problems?
  • LeonardoLeonardo Wake up and smell the glaciers Eagle River, Alaska Icrontian
    edited November 2006
    Hardware or Networking - your call. Make sure that you put in a link to this thread.
Sign In or Register to comment.