netgear router
i just bought a netgear router (model: RP114) to replace my old accton router that suddently died. however, i cant get it to connect to the internet. all my configurations and settings seem to be correct as i've previously set up the accton router without a glitch. the status of the WAN port shows IP address: 0.0.0.0 which means no connection at all.
im using PPPoE to connect to aDSL. any help is appreciated. thanks.
http://www.netgear.com/products/prod_details.asp?prodID=93&view=
im using PPPoE to connect to aDSL. any help is appreciated. thanks.
http://www.netgear.com/products/prod_details.asp?prodID=93&view=
0
Comments
http://www.netgear-support.com/ts/doc/ispguide.htm
I would check to see if your ISP is listed there and follow the link.
Do you need to register the WAN MAC address of the router with your ISP? Do you need to enter a Domain & System Name in the router for your ISP details? Have you tried powering-off the cable modem for a few minutes to see if that does it?
Regards
Bill
Are you sure the other router died or is there a fault with your line or with your isp?
mD
Duh, it would have worked if I'd read the post correctly - missed that damned pppoe. I always assume that everyone has the wonderful benfits of Blueyonder cable. I'll go back to sleep now!
Regards
Bill
I take it that one is now working? Just making sure.
You can probably sell the old router on and not make much of a loss, so it wont be all bad.
NS
NS
www.streamyx.com
NS